View single post by muddymickey | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Feb 22nd, 2016 07:10 pm |
|
||||||||||||
muddymickey
|
Could I do this: 1) Buy an ETH03 daughterboard, and temporarily fit in in place of the Z-Wave daughterboard 2) Use it to update the UCM/USB firmware with the cable 3) Refit the Z-Wave daughterboard 4) Remove the USB daughterboard and fit the ETH03 daughterboard So I end up with: 1 x UCM/Z-Wave 1 x UCM/ETH03 Or have I completely missed the point I'm half considering an ethernet interface, so wondered if this could be a cost-effective route to it. Last edited on Monday Feb 22nd, 2016 07:11 pm by muddymickey |
||||||||||||
|