| PM | Quote | Reply | Full Topic |
| Joined: | Monday Apr 27th, 2009 |
| Location: | |
| Posts: | 48 |
| Status: |
Offline
|
I can successfully control it via Domoticz running on a Raspberry Pi, using an Aeotec Z-Stick Gen 5 as the primary controller.
I also recently purchased a Z-Wave UCM for Comfort and fitted it, as I want to operate my lights based on PIR sensors via Comfort (as I did with X10). I've just updated the main Comfort firmware from 5-something to 7.093. The Z-Wave UCM is running firmware 7.013. I also have a USB UCM running firmware 5.178.Comfigurator reports version 3.10.11.0. Comfort has learned the Z-Wave configuration OK from the primary controller,
I can see the Fibaro as a "Routing_Slave-Power_Switch_Multilevel" with node type of "MultiLevel Sensor". The "Switch Device On" and "Switch Device Off" buttons in Comfigurator DO work OK. "Switch Device On" causes the dimmer to turn on at the last dim level (which was set either via Domoticz or the momentary wall switches). Presumably if Comfort can turn the lights on and off via these buttons in Comfigurator, I should be able to do the same in a response somehow ?
However, the only Z-Wave command I can choose in a response is a "Basic Get Command".
Any suggestions ?
| Close Window |