View single post by slychiu
 Posted: Saturday Nov 7th, 2015 09:35 am
 PM  Quote  Reply  Full Topic 
slychiu



Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Comfigurator 3.10.8 (Beta) changes

Known Issues
  1. In Zwave, after doing a Learn from Zwave, Flag mappings are changed into Counters in Zwave Mappings in Comfigurator.  However this does not affect the actual mappings in the UCM/Zwave, only in the displayed mappings in Comfigurator. To workaround, do another Read from EEPROM for Zwave.

Bugs Fixed
  1. UCM/CBUS2 Limit of concatenated bytes is limited to 17 so that there is no overflow. Previous versions limited it to 18 bytes which is too much.
  2. In KT03 where write to KT03 failed to any reason, the message "KT03 Upgrade timed out" was changed to "Write/Read to KT03 Timed out"
  3. In KT03, if a button has a status for Zone > 64, read from KT03 will cause the zone to be blank
  4. Fixed BUG. After Module scanning, KP06 and KP04A mdoules which are removed from the system were not shown. They should be shown in red with the status "Not Found". Only Modules with properties in memory eg UCM/KNX, KP06, KT03 etc will be shown as Not Found. Modules that do not have saved properties will not be shown at all in the modules list if they are removed from the system.

New Features
  1. Scanning for Modules has been speeded up greatly. What took up to 1 minute now takes only a few seconds, due to a new  scanning method. This requires Comfort Firmware 7.090 (now in Beta). Older firmware will use the old scanning method.
  2. For Logic Engine, the message "Vocabulary does not match" has been removed, since Logic Engine does not have a vocabulary
  3. Timers (in Names > Timers) has a field  called  Timer Status. The "Show Status" button will show the Timer as OFF or ON, and if ON, the remaining timer in seconds is displayed. This is a useful tool when programming and testing Timers.           
  4. "Clear Event Log" button has been added to the Event Log window. It is good practice to Save the event log and delete it so that old events are not lost    
  5. In System Information, "Vocabulary Number" eg 5, has been changed to "Vocabulary Name" eg "English Residential"
  6. The Action "Send RS232" applies to all UCMs, not just the general UCM, so that new commands can be sent to other UCMs which are not supported before.

Last edited on Saturday Jan 23rd, 2016 05:53 am by slychiu

 Close Window