View single post by slychiu | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Nov 2nd, 2015 06:33 am |
|
||||||||||||
slychiu
|
We have looked at the cclx fileThe problem is that the universal baud rate is set at 76800 as shown below This is used for communications to rs232 interface to external devices which require a certain baud rate. The baud rate applies to the UCM to submodule and to the external device via RS232 However this is meaningless for ethernet because a baud rate is not applicable for TCP/IP TCP/IPdoes not have a baud rate.The UCM would send data to the ETh03 submodule at 76800 baud according to these settings, but the ETH03 accepts data only at 9600 baud. Please change the baud rate to 9600 This should be better spelled out on the documents Attachment: bfafafdc.png (Downloaded 26 times) Last edited on Monday Nov 2nd, 2015 08:22 am by slychiu |
||||||||||||
|