ident
Joined: | Wednesday Aug 9th, 2006 |
Location: | Singapore |
Posts: | 3493 |
Status: |
Offline
|
back to top
|
- Get a ucm/eth03, and without configuring it as a UCM (since its not supported in V5), I can use it to upgrade directly to the latest firmware V7 on the main panel with a laptop.
[size=You dont have to configure it as a UCM, just connect it to Comfort and remove the old UCM01 which may have the same ID on the bus]- Once done, I reset the system (will it recognise my still V5 slave?)
[size=Remove the programming cable from the Comfort and connect it to the slave][size=dont worry about the slave until you upgrade that. ]- I then upgrade the slave with the programming cable and reset the system again.
[size=yes]- I install the UCM/ETH03 and get it working in its final resting place. (hopefully I can get it working with comfigurator). Will the UCM01/serial still be functional if not?
[size=The UCM/ETH03 can work regardless of where you install it as long as its ID is set to 1 and it is unique. UCM01 should be set to the next available id]- I can upgrade the universal UCM if necessary using comfigurator, but it will work without upgrade as far as I can see?
[size=If it is working for what yoyu need to do then no need to upgade]- Alas, looked at my cbus UCM, and it doesn't have a socket for an eeprom, although I'm sure I read somewhere that it can still be upgraded?
[size=You can send it back to us to add the socket and EEPROM, or perhaps your distributor can do it for you. Or you can leave it as it is]
|