View single post by Ingo

Posted: Sunday Aug 9th, 2015 08:14 pm

Joined:	Sunday Jan 21st, 2007
Location:	South Africa
Posts:	598
Status:	Offline

Your best bet would probably be to put some sort of Flag in the mix. My thinking is that if EG. Flag01 is set then skip the response internals (meaning the light is On already) or if Cleared (Light Off) then execute the response normally.

Setting Flag01 should probably be done in a response where you manually turn the lights on, in my case a Counter is set from Cbus so I would just Set|Clear Flag01 as the light changes state. You could also use a Counter if it's mapped to your lights.

I might not work at all but it's the avenue I would try.

Ingo

Close Window