Comfigurator 3.10.4 has the following changes;- In Responses, "Execute Response" button is above the User Comments so it can be easily seen
- In KT03 Configurator, Write KT03 System Properties and Read KT03 System Properties buttons have been added. KT03 system properties are added. Requires KT03 7.070, ULT 7.076, UCM 7.069 minimum firmware
- New Action Divide has been added (requires Comfort Firmware 7.076), see http://www.comfortforums.com/forum92/4220.html
- Exception in Show References when show status button is checked has been fixed
Known Issues- In KNX configurator, test buttons for KNX Group address 1/7/X do not work, but action codes to send commands to 1/7/X are not affected
- In Cbus configurator, test buttons for Cbus group address 15 do not work but action codes to send commands to Group addesss 15 are not affected
- Zones and Control Menu have "Alternate Phrases" where you can enter any text other than the set of words in the vocabulary. This is used in SMS messages for UCM/GSM4 and in the Comfort apps. When the text in alternative phrase is entered and then deleted, the field remains as blank and a blank Button appears in the Comfort Apps. This will be corrected in the next Comfigurator
- For KT03, read from KT03 where a button is set to Status = Zone > 64 will result in the zone being blank (unassigned).
- In Zwave, after doing a Learn from Zwave, Flag mappings are changed into Counters in Zwave Mappings in Comfigurator. However this does not affect the actual mappings in the UCM/Zwave, only in the displayed mappings in Comfigurator. To workaround, do another Read from EEPROM for Zwave.
Last edited on Saturday Jan 23rd, 2016 05:52 am by slychiu
|