back to top

1. In UCM/Zwave, the Virtual Node Info button is missing
2. various bugs in ucm/ehome
3. KT03 Button programmed to activate Response does not work - it sends Keypad key command instead
4. Read from Comfort will cause Functions > Thermostats to fill up the unused Thermostats with sensor 0 and assign Heating and Cooling Outputs to Output 1. You will not be able to control Output 0 after reading from Comfort.  In order to free up Output 0, unasssign the outputs from each Thermostat
   

1. When attempting to upgrade Comfort version 6 firmware via UCM and Comfigurator, error message "Module, Comfort & UCM version must be at least 7 to upgrade this module's firmware by bus. Please upgrade using the UCM programming cable." It should be possible to upgrade Comfort firmware version 6  to version 7 using UCM firmware version 6

1. When KT03 landscape is changed to Portrait, a pop up message warning that the screen orientation has changed, and any screen elements which are outside the screen boundaries will be moved so they are visible.
2. UCM/Universal allows baud rate 57600 bps. This requires Universal 7.065 firmware

1. Support for new UCM/e-Homegreen interface see http://www.comfortforums.com/forum47/4110.html

Last edited on Wednesday Mar 25th, 2015 05:31 pm by