View single post by wexfordman
 Posted: Monday Jan 12th, 2015 12:54 am
 PM  Quote  Reply  Full Topic 
wexfordman

 

Joined: Monday Jan 1st, 2007
Location: Cork, Ireland
Posts: 546
Status: 
Offline

  back to top

Vangelis wrote: I hate to say it but I did post on page 3 of this thread, but it must of been missed with all the investigation work going on.....

As for Life Support, this would be a combination Oscilloscopes / Logic Probes / Mains Noise Monitoring that would need to be connected to and around the main Comfort system - Something that is just not viable

Now that we hopefully understand the cause you can continue to enjoy and evolve your Comfort setup, whilst being mindful you might need additional noise suppression due to the problems seen in this thread

Vangelis


Oops, didnt spot that, sorry, would have saved  week or two of grief :-)
Well, one good thing is, I now have a spare velbus  chan relay, so can add a few more bits on the end of that too.
Im going to do a general tidyup of the wiring over the summer, Ive ordered some velbus power and data bus connections to easier daisychain the power and bus without having to use cable, it will be more reliable I reckon, although I dont think Ive had any problems within velbus to date.
I want to tidy up the ka/kb connections within comfort also, I have 6 devices around the house, within comort Ive used a connecting block to ie them all together, I think I could do this a bit neater as well.
Overall, spring clean time on the automation front:-)
On a related note, I've noticed a good few weeks ago that my camera system seems to have some noise on it too..... will check that out a bit further (its on the same circuit as the oil heating too)
Might get the boiler serviced too :-)

Last edited on Monday Jan 12th, 2015 12:56 am by wexfordman

 Close Window