| PM | Quote | Reply | Full Topic |
| Joined: | Sunday Oct 2nd, 2011 |
| Location: | |
| Posts: | 221 |
| Status: |
Offline
|
So what I have found out tonight is if I setup the association in Vera (main controller) and click update on HS on the PIR node it pulls the association information through.
Both HS and Vera show a status change of the PIR in sync the only thing is the status of the comfort VN doesn't change in any of the systems.
If I go in to comfort Under Zones/Inputs, select the zone and check "Show Status"(Zone Properties on the right). The "Zone State" will display the current state. and tick and untick the box it always remains inactive
I am confident that the association is working in principle its just not updating comfort. By all accounts I should not need to write to the eprom after and new association is created, but I have tried this on several occasions.
Last edited on Wednesday Oct 15th, 2014 05:03 am by lwillerton
| Close Window |