ident
Joined: | Wednesday Aug 9th, 2006 |
Location: | Singapore |
Posts: | 3493 |
Status: |
Offline
|
back to top
|
ULT 7.061 Beta firmware can be downloaded from http://www.cytech.biz/product_details.php?item_id=210
The changes from 7.057 (including those of 7.059) are
Know Bugs
- When Zone Restore Box is checked, meaning when he zone is restored following an alarm, it may not report the zone restore to CMS or GSM in some cases. From 7.059
- Sending SMS to Comfort with UCM/GSM will reply "Unknown command" if there is no control Menu Feedback, even though the control is performed correctly
Bugs Fixed- Fixed BUG m! And M! did not check for authorisation of users
- Prevent hogging of bus by constant LI with wrong code by not replying wrong login attempts by UCM until a correct code is entered on the keypad
- Fix bug which caused app to report rs485 communications failure alarm after the rs485 comunications failure is restored.
- Fixed bug from 7.056 where slave ID reported is not correct when there is low battery alarm from Slave or other trouble alarm.
- Fixed bug - if new alarm is idle eg system armed and disarmed and there is existing trouble alarm which caused beeping trouble siren, eg arm/disarm and siren is already on due to trouble alarm, 3dH alarm type is not sent to rs485. Causes no email from eth03 when system is armed and there is eg low battery
New Features- New action 156 to turn on/off keypad backlight. format is 156, Keypad ID, command where keypad ID = 65 (ID 1) to 95 (15) or 64 (all keypads), command is 0 for off, 1 for on. eg 156, 65, 1 turns on the backlight for Keypad 1. 156, 64,0 turns off all keypads backlight. Comfigurator (uo to 3.9.0) Response wizard does not support this new action. Note that when the action code turns on the backlight, it will not turn off unless an action to turn off is set to it, or if the keypad buttons are pressed.
Improvements- Send AM report before zone triggered AL alarm eg Panic, intruder, Fire so as to be consistent with other alarms where AM precedes AL
- The Blinds Function allows outputs in sem and rio to be used
- When zone trouble is activated, send AM01zz before AL.when zone trouble is restored, send AR01zz. Previously, AM and AR reports were not sent for zone trouble active and restore
- If a user flag is set or cleared, always broadcast to RS485 even if it is not changed from previous state. However The ID of the device which orginated the flag command wil be in the Rs485 message (Comfort is ID 1). Night Flag is an exception as it will not be broadcast if there is no change.
- If time is changed by DT command is less than +/- 4 seconds, Comfort accepts the time change ut does not report it to Rs485 (DT command) or event log in order to reduce the amount of reports
Last edited on Saturday Apr 18th, 2015 10:28 am by
|