View single post by ident
 Posted: Thursday May 1st, 2014 09:30 am
 Full Topic 
ident



Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

Please take note of bugs recently found in 3.8.7

Please upgrade to Comfort firmware 7.057 (or above), as older firmware may have extra keypads 9 to 15 appearing after a scan


Also In Comfigurator, go to File > Update Defaults
You need to have an Internet connection

This should update the defaults from the server
Then open the file again and scan for all modules


Known Bugs
  1. Read User Codes does not work (from 3.6.5)
  2. When UCM/CBUS1 has been upgraded to UCM/CBUS2, opening the cclx file may give a message "UCM/CBUS1 Actions have been converted to UCM/CBUS2. Please write to Comfort" even though the actions have been converted. The problem is that the response source was not being regenerated when a CBUS1 action occurred within an If or Else block. The workaround is to open the Cbus Responses in Response Wizard, which will regenerate the Cbus2 actions correctly

Last edited on Thursday May 22nd, 2014 09:52 am by ident
 Close Window