View single post by ident
 Posted: Tuesday Apr 29th, 2014 04:46 pm
 Full Topic 
ident



Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

Comfigurator 3.8.7  can be downloaded from http://www.cytech.biz/comfigurator.html

Please upgrade to Comfort firmware 7.057 (or above), as older firmware may have extra keypads 9 to 15 appearing after a scan

This is a minor update which fixes some bugs and introduces some useful features
The changes are

Known Bugs
  1. Read User Codes does not work
  2. Cbus1 actions which are not in the Lighting application are not converted correctly to Cbus2
  3. When UCM/CBUS1 has been upgraded to UCM/CBUS2, opening the cclx file may give a message "UCM/CBUS1 Actions have been converted to UCM/CBUS2. Please write to Comfort" even though the actions have been converted. The problem is that the response source was not being regenerated when a CBUS1 action occurred within an If or Else block. The workaround is to open the Cbus Responses in Response Wizard, which will regenerate the Cbus2 actions correctly
  4. Extra keypads 9 to 15 may be detected after a scan using Comfigurator 3.8.7 to 3.8.8. This happens if the scan is done after initialisation. Go to File > Update Defaults to update the default files (This needsan internet connection) Also you can upgrade to ULT 7.057 which does not have this problem
  5. Options > Default KT03 Template causes  an exception
Bug fixes
  1. Fixed bug inserting Else condition in the middle of nested If/Then actions in Response Wizard
  2. Fix reporting problem in the new Event Window (Comfigurator 3.8 only) with "Line Cut - Controller" reporting as Line Cut User #15

New Features
  1. Modify format of CBUS2 actions for Enable and Trigger Applications, and added Custom Application
  2. Display warning to Write to Comfort if CBUS1 actions have been converted to CBUS2 after a firmware upgrade from UCM/CBUS1 to UCM/CBUS2.
  3. Remove Auto-assign ID and Unassign ID options. These were introduced  earlier but are not very useful with he new Scanning for modules feature.
  4. Allow outputs for blinds and thermostats to be referenced elsewhere. Previously blinds and thermostats could not use outputs that were referenced anywhere eg in Responses or where outputs are used as status eg in KT03 and Control menu
  5. Support drag and drop of flags, counters, timers and sensors. The Responses or references like Cbus or KNX mappings are automatically changed
  6. Support > 8 keypads where relevant.
 
 

Last edited on Tuesday Jun 17th, 2014 08:57 am by ident
 Close Window