| Full Topic |
| Joined: | Wednesday Aug 9th, 2006 |
| Location: | Singapore |
| Posts: | 3493 |
| Status: |
Offline
|
I appear to have this CBUS UCM, but I DO have a U2 socket, which is not populated. Is this able to have the upgrade
If you have a U2 socket, then you can add an EEPROM min 64 Kbits eg 24LC64 so the baseboard is compatible.
However the top submodule must be the newer ST7 type which is shown in the photo
If you upgrade the UCM/Cbus1 firmware to UCM/Cbus2, the status bar will show you if the EEPROM is missing, or the submodule is not the ST7 type.
You can then get the submodule or EEPROM, or alternatively you can downgrade back to UCM/CBUS1
Do NOT try to solder an IC Socket or eeprom into the PCB if there is no IC socket on the UCM/Cbus baseboard as it requires special soldering toold
Last edited on Friday Aug 1st, 2014 03:14 pm by ident
| Close Window |