back to top

1. File > Update Defaults failed if not logged in as Administrator
2. In Function > Thermostats, the heating and cooling outputs could be repeated, Outputs should be restricted to only one Thermostat
3. In Function > Thermostats, the heating/cooling numbers did not correspond to  the correct output names.
4. In Functions > Blinds, select "No stop" for stop method assigned 3 outputs.
5. In Functions > Blinds, outputs were restricted to 16
6. In user Mode, Heating and cooling setpoint could be decreased to negative
7. In user Mode, Heating and cooling status cannot were read only so cannot be switched on or off
8. In user mode, Control Menu actions did not work when clicked
9. Blinds were programmable for 1 to 4 only. 5 to 8 were not selectable
10. In User Mode, Thermostat status is read only, it should be read/write
    

1. For Firmware Upgrading in Modules, "Download Firmware Upgrade" is  a new option. This allows the latest released firmware to be downloaded so it can be used for upgrade later
2. Supports the new UCM/CBUS2 which is yet to be released