View single post by ident | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Sunday Feb 2nd, 2014 10:35 am |
|
||||||||||||
ident
|
UCM/Heatmiser with the ETH03 submodule is required for Heatmiser wifi modules You do not need the Heatmiser Netmonitor Connect the Ethernet port MJ101 on the ETH03 to the Local Area Network (LAN) by means of a hub or switch using a parallel CAT 5 cable. The WiFi Heatmisers should be connected to the same network Comfort Server Manager (CSManager) software is used to configure ETH03 to have Heatmiser related settings. The software is included in Comfigurator 3.7.8 and above or can be downloaded from Cytech website at http://www.cytech.biz/comfort_server_manager.html In Comfigurator 3.7.8, go to Options > Settings > UCM Connections and select Network (Local). Click on the link for Comfort Server Manager. When the ETH03 is connected in the same physical network then Comfort Server Manager will automatically discover it. Ensure the Version has the word HM (for Heatmiser) i.e. Eth3HM-v1.04 for the current release. The ETH03 firmware for Heatmiser can be downloaded from http://www.cytech.biz/eth03_firmware.html Download ETH03-heatmiser.zip and unzip to a hex file. To upgrade to change the ETH03 firmware to Heatmiser, select the ETH03 IP address and click on the 'Upgrade' button on the bottom right. Select the downloaded ETH03-heatmiser.hex file 'Clear List' button clears the display on the Comfort Server Manager screen. The 'Discover Devices' button is used to discover any ETH03 module that is connected to the same network e.g. after 'Clear List' 'Reboot' button reinitialises the ETH03 module. By default the ETH03 is set as DHCP enabled. Uncheck the DHCP checkbox and enter the new IP and Gateway fields to assign a fixed IP address for the ETH03 module. Press the 'Submit' button to confirm. Routing Mode: Client (mode in use for Heatmiser) Port: 1001 (default) Target IP: The IP address of any one of WiFi Heatmiser module Target Port: 8068 (port in use in WiFi Heatmiser, this is fixed) Timeout: Not used in UCM/Heatmiser Last edited on Friday Aug 1st, 2014 06:28 am by ident |
||||||||||||
|