View single post by simond | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Sunday Nov 17th, 2013 11:43 am |
|
||||||||||||
simond
|
Just installed the UCM/Heatmiser and integrating with my heatmiser network. Couple of questions... Firstly, can you put the thermostat in 'frost protection set back' mode? E.g. by setting the 'Thermostat' flag in comfort it turns the whole thermostat off - LCD and all... On the thermostats they have a 'power' button which when press turns off the program and turns on 'frost protection' mode, and the snowflake appears on the thermostat. This would allow me to 'set back' when going into vacation mode... Secondly - I'm finding I often have to write values twice. For example I have 5 thermostats on the network (plus a NetMonitor, which was off during learn) and I have a a Response that sets the 'Theromstat' flag on them all off. I find if I run the Response it doesn't always hit them all, but if I run it twice it does. Any ideas? Finally - 'Get Status' in Comfigurator is greyed out, so I can't see any status information.... Looking good though, another nice easy integration which makes life easier than using IR codes etc... Cheers Simon
|
||||||||||||
|