View single post by ident | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Friday Oct 4th, 2013 12:19 am |
|
||||||||||||
ident
|
Can you check the behaviour of the leds on the UCM/Cbus? When Confort sends a commnand to CBus the BUSY2 led turns on When Cbus acknowledges the message, the BUYSY2 led goes off so it should blink If there is no acknowledgement fron the target group address the BUSY2 led stays on When it sees a message from Cbus the Busy1 led bllinks If the bus is disconnected or has an error the ERR led blinks
|
||||||||||||
|