back to top

Comfigurator Beta 3.7.4 can be downloaded for testing
Please UNINSTALL 3.7.3 or previous versions of 3.7 before installaing this version due to a problem with instaling the default templates

The changes are

Bugs Fixed

1. Local Timezone in the default templates was set to London/Dublin/Edinburgh and users in other countries using Windows 7 may have their Comfort sets to the wrong time zone.

1. The colour of Not Polled Modules after scanning has been changed from Blue to Purple so as not to confuse with referenced modules and responses which are in blue
2. Improvements in GSM4 and Zwave modules which require new UCMs yet to be released
   

1. Some PCs may have UCM connection if USB wrongly set to Via KT03 even though KT03 is not present and the Voa KT03 box is not seen. The workaround to remove this is to add a KT03 in Modules, go back to Options > Settings and uncheck the Via KT03 box
2. For KT03, write to KT03 by direct USB connection fails with error popup "Failed to Connect to KT03". However upgrading firmware and using KT03 USB as a UCM is not affected. Write to KT03 by Bus can also work.
   
3. Some of the updated default templates are not updated by this software version. Please uninstall the previous 3.7.x version before installing this version
4. If KT03 configuration is erased (eg due to incomplete write) Reading from KT03 will cause an Exception
5. If a Zone Type which has no Normal Alarm Type (eg Zone Type 30 Digital NO) is assigned to an alarm type, then it causes all zones to be assigned to the changed zone Type
6. If there are 2  UCMs connected to Comfort which have  correct ID but Comfort is configured for 1 UCMs, and the cclx template has default 1 UCM, Scanning for All modules will show the 2nd UCN as "Not Polled" which is correct. However scanning for All Modules will not work - no scan is done. However scanning for UCMs only in this case works.
   

Last edited on Sunday Sep 29th, 2013 02:22 am by