| PM | Quote | Reply | Full Topic |
| Joined: | Tuesday Jan 31st, 2012 |
| Location: | |
| Posts: | 138 |
| Status: |
Offline
|
Now I think I have fubar'd the ETH2 Module by following the instructions...Fired up DS Explorer and it discovered my UCM (only the hammer and not the Blue barrel) so there was only one line visable, with an IP address in the same subnet as my hub (weird)
Downloaded the firmware .bin file and uploaded it via DS Explorer - progress bars stayed blank, so I waited...and waited (instruction state it should only take seconds)
So I hit cancel (think this is what broke things), I the refreshed on DS Explorer and got the same 'hammer' identifyer but now with a 1.0.0.1 IP address (again, weird)
Tried uploading again and still no progress bars, so hit cancel. Now when I hit Refresh on DS Explorer I don;t see the UCM module and on the RJ45 Connector both the Green and Yellow LEDs are flickering very fast
Unplugged the module from the power and plugged back in again - still flashing RJ45 Connectror LEDs - hence suspician is it is now fubarred
- Not happyThoughts?
| Close Window |