back to top

1. When exit from a configuration or loading new file, message "Configuration for module UCM has changed or the number of Responses referenced by the module have changed" may appear even though there is no such change or the module has no eeprom
2. If a module firmware is too old so that it does not report its firmware during a module Scan, the previous modules firmware was reported instead
3. When scanning is being done and a Communications Failure occurs during the scan, Comfigurator may report that a module does not support scanning, due to a long delay in replying due to the Comms failure report
4. If Comfigurator is opened with a diferent file system to the Comfort which is connected, Conversion of file system to the correct one after a scan may cause an exception
5. If last connection was by KT03 USB, and a new file is started without KT03 in the configuration, the connection is still by KT03 USB but the box "Via KT03" is not visible and so cannot be disabled. The workaround is to add a KT03 to make  "Via KT03" visible, then uncheck the box

1. If a module is "Not Found" after a scan ie listed in RED, and the configuration is written to Comfort, this will not cause  a Communications Failure. This is because modules that are not found by Scannning will not add to the module count.
2. " File Creation Time" in Configuration > System Information has been renamed "Last Saved". This is a more accurate description as it shows the time that the  cclx file was last saved.

1. Local Timezone in the default templates is set to London/Dublin/Edinburgh. Users in other countries using Windows 7 may have their Comfort sets to the wrong time zone. Windows XP does not have this problem
2. USB via KT03 may be set in Options > Settings when KT03 has been removed. You have to add bak KT03 in order to uncheck the Via KT03 box
   

Last edited on Sunday Aug 25th, 2013 09:53 am by