View single post by Home | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Tuesday Aug 6th, 2013 05:00 pm |
|
||||||||||||
Home
|
Clive Make sure you upload the current software from the C1 - This can be loaded into the latest version of comfigurator and thus translated to a .cclx file. If its not a large or complicated set up then it may be as well to start from scratch. We use a template that is more or less blank (no responses that are redundent). You will need a new RGR05 Go careful of the current firmware with scanning and old keypads - read posts etc - it adds additional keypads. You wont get full duplex through the KP03's but if you dont use them with the door station or as intercom this should not be a problem New board is same size as old but cabling needs slight alteration. UK distributor - I suspect that the main one is http://www.cbus-shop.com You will need a new Ethernet UCM. Hope that this helps A
|
||||||||||||
|