View single post by ident
 Posted: Monday Jul 29th, 2013 11:14 am
 PM  Quote  Reply  Full Topic 
ident



Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

One thing I've noticed, if you set show status checkbox on say FLAGS or OUTPUTS, you can highlight a row and then press down arrow key to move focus to the next rows. I.e. when it refreshes the status it refreshes and jumps back to the remembered/current row.
I dont see this at all
When you check show status on flags the highlight disappears and all flags are status are updated almost immediately
The same with outputs
I cannot get it to remember where it was before

Flags and output status are updated by a single command while counters and sensors need individual commands to get status which may account for any diference that you see

But I dont see any advantage to your preferred behaviour

 Close Window