Comfigurator 3.7.2 (Beta) can be downloaded from http://www.cytech.biz/comfigurator.html?category_id=98 for testing purposes
Please note the following known bugs in this software
Bugs in Comfigurator 3.7.2
- When exit from a configuration or loading new file, message "Configuration for module UCM has changed or the number of Responses referenced by the module have changed" may appear even though there is no such change or the module has no eeprom
- If a module firmware is too old so that it does not report its firmware during a module Scan, the previous modules firmware is reported instead
- When scanning is being done and a Communications Failure occurs during the scan, Comfigurator may report that a module does not support scanning, due to a long delay in replying due to the Comms failure report
- If Comfigurator is opened with a diferent file system to the Comfort which is connected, Conversion of file system to the correct one after a scan may cause an exception
- If last connection was by KT03 USB, and a new file is started without KT03 in the configuration, the connection is still by KT03 USB but the box "Via KT03" is not visible and so cannot be disabled. The workaround is to add a KT03 to make "Via KT03" visible, then uncheck the box
Last edited on Friday Jul 26th, 2013 08:42 am by ident
|