chinz_minz
Joined: | Monday Sep 3rd, 2012 |
Location: | |
Posts: | 9 |
Status: |
Offline
|
back to top
|
Thank you very much for your help.
Now i'm trying it.
hendy wrote: The 2 wires are referring to the bus wires of Cbus.
In the Cbus dimmer module that you have they will be located at "C-bus CONNECTIONS" port.
Notice that this is using RJ45 connector. RJ45 cable will have 8 wires inside.
You will need to strip the other end of the cable and take out the 2 wires at the middle (these are the 2 wires referred above) to be connected to UCM/Cbus.
There will be polarity on these 2 wires.
If it is correct wires and polarity then the 2 red LEDs on UCM/Cbus daughterboard will light up when connected; otherwise try to reverse them.
|