View single post by hendy | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Thursday Jun 6th, 2013 01:04 am |
|
||||||||||||
hendy
|
The 2 wires are referring to the bus wires of Cbus. In the Cbus dimmer module that you have they will be located at "C-bus CONNECTIONS" port. Notice that this is using RJ45 connector. RJ45 cable will have 8 wires inside. You will need to strip the other end of the cable and take out the 2 wires at the middle (these are the 2 wires referred above) to be connected to UCM/Cbus. There will be polarity on these 2 wires. If it is correct wires and polarity then the 2 red LEDs on UCM/Cbus daughterboard will light up when connected; otherwise try to reverse them.
|
||||||||||||
|