View single post by ident | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Posted: Saturday Jun 1st, 2013 05:56 am |
|
|||||||||
ident
|
The older version of UCM/USB is shown below. The difference is the new version has DIP switches ABCD instead of Shunts for SW7 Primary RS485 ID Connect the UCM to Comfort using the 4 way RS485 cable below DO NOT CONNECT the UCM Firmware programming cable shown below! This is only used for upgrading firmware UCM Firmware programming cable. DO NOT CONNECT The RS485 ID(SW7) determines the ID of the UCM. By default, the UCM ID is set to 1 ie ABCD are all ON. Leave this at default ID The UCM/USB is supported by Comfigurator 3.x. Switch on Comfort with the UCM/USB and connect the USB cable to the computer. When the UCM/USB is connected, a message "New Hardware Found" should appear, and the USB driver should be installed automatically. If the appropriate driver cannot be found then a dialog to install the driver appears Select "Install from a list or specific location (Advanced)" and then click "Next". Select "Search for the best driver in these locations" and browse to ("C:/Program Files(x86)/Cytech/Comfigurator3/USB Drivers") . Once the file path has been entered in the box, click next to proceed. The driver should be installed and "Hardware Ready for use" is seen. If the driver fails to install correctly, this may be due to an old version of the driver already in the PC. See the forum topic http://www.comfortforums.com/view_topic.php?id=2431&forum_id=73 for instructions on how to fix this problem Once the driver is installed, go to Options > Settings > UCM Interface. Select USB from the dropdown list Click on the blue link "Scan for USB Devices " as shown above Then click on the dropdown list to the right of Serial Number. You should be able to see a serial number in the dropdown list. If the dropdown list is blank, unplug and reconnect the USB cable and repeat clicking on "Scan for USB Devices" Do not check "Via KT03" unless the USB interface connected to KT03 If the serial number can be seen, press OK. You are ready to connect to Comfort as explained below Last edited on Wednesday Feb 18th, 2015 12:19 pm by |
|||||||||
|