gaynorc
Joined: | Sunday Dec 31st, 2006 |
Location: | Ireland |
Posts: | 130 |
Status: |
Offline
|
back to top
|
I checked Zone 31 (Hex 1F) several times and on each time received the 70 response. At the same time the "module status" in comfigurator reported 112 (the decimal equivalent of hex 70), so I am certain about that reading.
As I explained in my previous post above, I then investigated the sensor on that zone (an inertia sensor)and activated it several times. The reading then returned to hex 60, decimal 96 under "module status", where it now stands. I will check this from time to time and copy the I/O message stream to you if I encounter values other than the four you mention.
|