Firmware 7.027
- Output command ON or OFF is ignored if the output state is unchanged
- Fixed BUG action 8 reset_outputs failed (from 7.007)
Bugs- Reminder Enable function does not work for Reminder Numbers 9 to 16. Reminder Enables for 9 to 16 are the same as Reminder 1 to 8. This affects Scheduled Reminders only.
- A Flashing output on a Slave cannot be turned off by an Output On or off command. Only Reset all outputs command can reset the output. Outputs 1 to 16 on the Main Comfort board are not affected by this bug
- Pressing buttons on SCS causes the corresponding LED (output) to flash until Comfort sends a command to switch it on or off (using Response). Due to the comparison of output states introduced in 7.027, the LED may remain in the flashing state.
Please upgrade firmware from Comfigurator 3.6.x Modules Tab right click and check for updates
Last edited on Friday Jul 26th, 2013 12:32 pm by ident
|