back to top

1. Scan for Modules where the module firmware does not support the scan command will report wrongly as module not found
2. if actions Bypass, Unbypass, Key arm, Auto arm or Activate Door stations are followed by other actions in a Response, then the other actions are not done. Workaround is to place the above actions as the last action in a Response
3. Actions  35 (Save Last Counter( 37 (Save Last Sensor), 121 (save Input value to sensor), 151 (Initialise Sensor) do not save the correct value
4. Action 148 Multiply by Constant gives wrong result. But multiply by counter and Multiply by sensor do work
5. Reminder Enable function does not work for Reminder Numbers 9 to 16. Reminder Enables for 9 to 16 are the same as Reminder 1 to 8. This affects Scheduled Reminders only.
   

Last edited on Friday Jul 26th, 2013 12:33 pm by ident