View single post by ident
 Posted: Tuesday Jan 22nd, 2013 07:21 am
 Full Topic 
ident



Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

Zwave Configurator (May require Zwave Firmware 7.xxx required)
  1. "Get Status" button will not log out after the status is obtained, Comfigurator will remain logged in to continue receiving status. Zwave 7.xxx will send status when there is any change, and not just when Get Status button is pressed.
  2. Colour Codes in Zwave Mapping  help to identify  various types of Nodes: Controllers (gray), UCM/Zwave (Blue), Virtual Node (Green), Slave Nodes (Black)
  3. After Virtual Node operations Comfigurator will automaticallly read EEPROM when required.
  4. Zwave Response Wizard supports a new Multilevel Dimming function
  5. If the Response sends commands to a Virtual Node a warning message  pops up "Sending Zwave commands to Virtual Nodes is not recommended as it is not guaranteed to work”
  6. In Response Wizard. "Basic Command" renamed to "Basic Set Command". "Status Request" renamed  to "Basic get Commands", to comply with standard Zwave terminology
  7. UCM/Zwave will update Comfort counters and sensors from Zwave commands even when the counter value has not changed. This allows status of Zwave devices controlled by Comfort and other Zwave nodes to be synchronised
  8. Help Text for Zwave commands has been improved
The status messages show the status of the UCMs which were formerly available only by seeing the state of the LEds BUSY1, BUSY2, ERROR eg for Zwave

Normal/No error
EEPROM missing/faulty
EEPROM insufficent capacity
EEPROM data invalid
Communication error between UCM baseboard and Z-wave sub-module
UCM/Z-Wave not in any network
Waiting to receive network data. (Learn process)
Receiving network data. (Learn process)
Writing EEPROM. (Learn process)
Learn process success
Learn process completed with errors
Command transmitted.  Waiting for ACK
Z-Wave network busy/jammed (RF transmit error)
Unknown transmit error


Velbus Configurator (may require UCM/Velbus 7.xxx)
  1. Added Get Status Command, also status messages will update automatically (requires Velbus 7.xxx)
  2. Added support in Learn Mode for new Velbus Modules VMBDMI, VMB8PBU, VMB6PBN, VMB2PBN, VMB6PBB (requires Velbus 7.xxx)
  3. Write and Read EEPROM times reduced
  4. Counter will be updated from Velbus even if the value does not change.This allows status of Velbus  devices controlled by Comfort and other velbus modules  to be synchronised
The status messages show the status of the UCMs which were formerly available only by seeing the state of the LEds BUSY1, BUSY2, ERROR
eg for Velbus
Normal/No error
EEPROM missing/faulty
EEPROM insufficent capacity
EEPROM data invalid
Communication error between UCM baseboard and sub-module

These are the status formerly only seen by reading the LEDs on the UCM/Velbus


Last edited on Wednesday Jan 23rd, 2013 03:26 am by ident
 Close Window