View single post by ident | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Posted: Thursday Nov 22nd, 2012 01:03 pm |
|
|||||||||
ident
|
If a module in the configuration is NOT found by the scan, it will be shown in RED The Status column in the middle pane also shows information like Scanned, Not Scanned, or Not Found Hence if a module has been removed from the network perhaps temporarily, and thus was not found during the scan, it is not deleted but is shown in red. If the module was a KT03 or UCM/KNX where many hours of programming work has been put in, the absence of the module during scanning will not cause the module with all its properties to disappear. It remains in the file and is not lost. If you really want to delete the module, then right click on it and select Delete Module. However it is not possible to delete a module that is referenced by Responses or other elements. Next, I will show how the new Firmware Upgrading method works Last edited on Friday Nov 23rd, 2012 10:20 am by ident |
|||||||||
|