View single post by TheMax74 | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Friday Oct 12th, 2012 04:26 pm |
|
||||||||||||
TheMax74
|
Hello, i noticed an important different behaviour than old firmware. If a KNX group address sends a "ON" telegram, successive "ON" telegrams will not trigger the response associated to the COUNTER linked to the KNX group address, until a new "OFF" telegram is sent. In other words, response is not triggered if the actual group address value is equal to the previous value. "KNX Group address value" versus "response" ON ----> trig response ON ----> OFF ---> trig response OFF ---> ON ----> trig response OFF ---> trig response etc.... With older firmware, the response was triggered everytime a telegram arrives, irrespective of the previous value. "KNX Group address value" versus "response" ON ----> trig response ON ----> trig response OFF ---> trig response OFF ---> trig response ON ----> trig response OFF ---> trig response etc.... May this related to this topic ? Please confirm if this is a bug or it's a normal behaviour that will be mantained in future releases. Thanks Keep up the good work. Best regards. Massimo Last edited on Friday Oct 12th, 2012 04:47 pm by TheMax74 |
||||||||||||
|