The new firmware is available from http://www.cytech.biz/ucmknx_firmware.html?category_id=101
Known Bugs
- KNX to Comfort for Keypad keys, Panic, Time, Date, Arm system, Bypass zone do not work.
Bugs Fixed- If a Floating Point Telegram Type is mapped to a Sensor, receiving a telegram may cause a telegram to be sent to KNX with the value of 1. This problem was reported in http://www.comfortforums.com/forum12/2150.html
- If a 1-bit Drive Control Telegram is mapped to a counter 255 this may cause a spurious Response from Comfort to KNX. This problem was reported in http://www.comfortforums.com/forum12/2816.html
Improvements- Send Floating Point EIS5 Telegram allows -32768 to + 32767
Please note that products purchased may not have the latest firmware. Firmware can be upgraded using another UCM and Comfigurator
Last edited on Tuesday Feb 19th, 2013 05:14 am by ident
|