View single post by ident | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Sunday Jun 17th, 2012 03:07 am |
|
||||||||||||
ident
|
The UCM/Dupline polls and monitors for Dupline Output activity for addresses A1 to P8, and saves the value to Comfort Counters. Comfort Ultra has 256 Internal Counters numbered from 0 to 255 which can be used as general purpose Registers or to hold the states of external devices like Dupline and C-Bus. Each Counter can hold a 1 byte value ie 0 to 255. Dupline output states are saved in the counter as values 0 for OFF, 255 for ON. When a Dupline Output command is received by UCM/Dupline, the state (ON or OFF) is kept in the mapped Counter register. The Mapping between Dupline Output addresses and Counters is shown below If the Output is Off, the value 0 is saved in the corresponding counter. If the Output is On, the value 255 is saved in the corresponding counter. This allows Comfort to Monitor the status of the Dupline Outputs and to trigger Responses based on each Counter.
|
||||||||||||
|