This is a pre-alert about the new firmware 6.020 which will be available soon
Update - ULT 6.020 is released http://www.cytech.biz/comfort_ultra_firmware.html
Bug Fixes- Fixed BUG from 6.011 when sign in "welcome" is not heard vmenu
Fixed bug upgrade sentence tab by itself did not work - Fixed intermittent problem for Firmware Upgrade by Comfort Bus.
- Fix BUG for handling GSM - if ucm ID was formerly GSM but another UCM type replaces it with the same ID in the system, it still tries to dial to GSM.
- Fix BUG Scan u? For SEM ID 4 and 5 did not work for 96 zones.
Improvements- UCM Download Button will first erase the whole U4 eeprom to improve speed of writing UCM U2 EPROM to Comfort. Needs UCM 6.019
- Disabled Siren Tamper alarm so shunt J4 SRNTMP has no effect. This alarm is not usually used and causes problems with the J4 shunt drops off.
- Improved Read/Write operations to U4 EEPROM whuch caused system to hang when read operations were interrupted
- Prevent Eeprom error at reset causing system to hang and escape Watchdog timer reset.
- Implemented Timer Runaway protection for Controller.
- Removed Adjust Daylight Saving Time Action 98 - not needed after Automatic daylight saving time change was implemented .
New Features
- Implemented Daily Time Adjustment location in seconds (Modules and Settings). Daily adjustment at 4 AM.
- New action Code Enable/Disable 152, user number 2-16, 1 for enable, 0 for disable, 2 for check. Save state when reset or system off. User 1 cannot be disabled. If eeprom location has user 1 disabled then all are enabled because this location may be set wrongly in eeprom before.
- Action 9 allows push button to be used to ring phones and keypad . If NO DPs then doorbell menu exits after say goodbye. When door station rings phones and entry door is opened, this automatically stops ringer without using action 26.
Known Bugs
- Assigning Output to Security > Status LED will cause KP Home/Armed LED to show the wrong status (from 5.220)
- Scheduled Reminder Messages do not work at the correct time (from 5.173)
- Reminder Enable function does not work for Reminder Numbers 9 to 16. Reminder Enables for 9 to 16 are the same as Reminder 1 to 8. This affects Scheduled Reminders only.
Importance
Important - for prevention of Comfort system hang due to system reset interrupting eeprom read/write
Last edited on Friday Jul 26th, 2013 12:37 pm by
|