| PM | Quote | Reply | Full Topic |
| Joined: | Sunday Feb 19th, 2012 |
| Location: | |
| Posts: | 20 |
| Status: |
Offline
|
The point is that I want to avoid as much as possible to use a central monitoring system to control "vital" component. Let's imagine that for any reason there is some issues with comfort. Then, it means that I will not be able to use the lights in the house anymore. Usually it's one of the reason why installers choose KNX technology : potential failure cannot happen at the same time on every devices. So, maybe one lamp will not work but the other will still be operative. If comfort failed, what about all the lightings ???
So, I've identified two other options :
- PIR event sends a ON telegram on an 1-bit mapped object in Comfort. The response to this event is to send a new KNX object with new Group Adress. This Group Adress is associated to a Virtual zone input which can be reset by sending a second KNX object after a given time :
Response :
KNX On UCM02 70
"Timer01 for 5sec"
KNX Off UCM02 70
But unfortunally, it doesn't look like the UCM/KNX can direclty get the KNX telegram sent from the Response... Can you confirm please ?
- PIR event sends a ON telegram on an 1-bit mapped object in Comfort. And Then either I can direct "simulate" a zonetype alarm with an action. So, it takes actions depending on the security modes of Comfort. But I cannot find such action???
Either I have to recode all the differents actions for every Security modes of Confort + Manage Entry Delay + Manage Dial-UP
Thanks.
| Close Window |