View single post by auredor | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Feb 20th, 2012 08:18 am |
|
||||||||||||
auredor
|
I agree with you. Normally, the sensor should send the OFF set. But I've set-up it in order not to do that because those same sensor are used for lighting switch on when movement is detected. The PIR mustn't send the OFF state because it will switch off the light. With lots of detections in a short time frame, this means that the light will be toggled a lots of time. And I want to keep a good reactivity with the PIR. So, I cannot increase the time interval between two detections. The light actuator has been set-up as a pulse fonction. It means that when receiving an ON telegram from PIR, it will switch ON and remain in this state for a given delay. However, the actuator should remain sensitive to OFF telegram coming from switch device to switch off the light when leaving the room. So, as PIR detector sends ON/OFF telegrams to both group adress, their behaviour is related. Comfort FileSystem : 34 Comfort Firmware : 254 Comfort Version : 6 Comfort Revision : 11 UCM/KNX Verison : 6.011 Other question : is there any french vocabulary available for Comfort or do I have to make it by myself (French Customer will not accept to get an english security system. Most of them doesn't speak english) ? Thanks.
|
||||||||||||
|