View single post by Ingo

Posted: Sunday Aug 28th, 2011 07:55 pm

Joined:	Sunday Jan 21st, 2007
Location:	South Africa
Posts:	560
Status:	Offline

And there goes mine as well... Commands from Comfort (Outgoing CBus commands) can get through to the Cbus network but Cbus changes does not get through to Comfort.

Let's see if we can correlate our H/W, I am running the following setup:

Comfort II with firmware 6.005
UCM/Cbus, ST7 SIM, with 5.216 (SW8 A&B shorted)
64 Zone (3 Slaves) with firmware 6.004
1 x RIO with firmware 2.007
2 x Keypads (KP04's)
1 x Doorstation
1 x UCM/Ethernet with firmware 6.008
1 x UCM/GSM with firmware 6.005

I had to do a UCM/Cbus reset this morning to get things going again.

Ingo

Last edited on Monday Aug 29th, 2011 04:13 am by Ingo

Close Window