eth02 firmware might not be compatible

[juwi_uk]

What does Device Explorer show?

[raygregg114]

also since the upgrade was done I cannot arm the system in either night or away mode. I did an upgrade to my GSM module and the Ultra 2 module yesterday. sine then nothing seems to be working.

[raygregg114]

was showing nothing and giving a message that auto discovery couldn\'t find anything. Initalised again and now showing blue barrel with IP address.

 

[juwi_uk]

Sounds like you are making progress then. So you can now also see in DS Manager and connect OK?

[raygregg114]

Yes, can click ion blue barrel and go into settings. Says IP address is 192.168.1.20, gateway is 1.0.0.1, DHCP is disabled and submask is 0.0.0.0

[juwi_uk]

Hi

Your Gateway and Subnet address do not look right to me.

I would have thought you would have

GW Address: 192.168.1.1
Subnet mask: 255.255.255.0

Julian

[raygregg114]

DS manager now cannot connect when I refresh, says no devices were discovered but I am running a constant ping and the IP is there.

[raygregg114]

Ran device explorer and rebooted. Went to DS Manager and refreshed, device was listed. Now when I refresh it says Reading SDF from device, no response.

[juwi_uk]

Not sure if this will help, but below are the settings for my ETh02. Perhaps generally compare and see if you have anything different (name/IP etc excepted). Wondering if perhaps baud rate is different etc on yours.

Julian

[ident]

Reading SDF from device is shown briefly when you double click the device or select settings for it
If you still have problems attach a screenshot of DS Manager settings