UCM Firmware upgrade when UCM has no notch?

[schford]

Hope someone can advice,

Brian (bs85) sent me his UCM/ethernet so I could get them both upgraded to latest 6.02 release.

My upgrade went straight in (though it took me a few mins to remember how to change IP address in tibo)...

I then swapped over to do Brians and noticed that his ethernet board does not have a notch in so I cannot insert the jumper to cover then 2 pins on PP2 to put it into programming mode....

Anyone got a quick easy solution for me so I can get it back in the post to him tomorrow?

Cheers

Stuart

[Ingo]

The Ethernet daughterboard can unscrew easily, remove it, insert the jumper and plug the daughterboard back in. Once done you can reverse the procedure.

Ingo

[schford]

Thanks all done!