Comfort Automation/ Security System Forums › Support › Questions on Programming Comfort v
0 to 10 volt detection

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
0 to 10 volt detection
Ghyllwood Offline
UCM Pi Users
Posts: 58
Threads: 19
Joined: Mar 2009
Reputation: 0
#1
03-25-2015, 02:56 AM
I have a humidity sensor that gives out 0 to 10 volts. Does anyone know if it is possible to read this voltage in Comfort so that I can output a command when the voltage reaches a pre-set value?
Find
Reply


Messages In This Thread
[No subject] - by - 03-25-2015, 02:56 AM
[No subject] - by - 03-25-2015, 05:43 AM
[No subject] - by - 03-27-2015, 01:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)