Comfort Automation/ Security System Forums › Support › Problems & Troubleshooting › Firmware Upgrading Problems v
Upgrading UCM Firmware

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Upgrading UCM Firmware
hendy Offline
Administrator
*******
Posts: 221
Threads: 1
Joined: Sep 2007
Reputation: 0
#18
12-16-2013, 08:46 AM (This post was last modified: 12-16-2013, 08:55 AM by hendy.)
What is the upgrade error message? \"DUT is not connected\" ?
If so, did you shunt the PP2 pins on the UCM/Cbus?
The PP2 (2-pin header) needs to be shunted during the firmware upgrade.
Find
Reply


Messages In This Thread
[No subject] - by - 09-10-2011, 10:41 PM
[No subject] - by - 09-11-2011, 02:13 AM
[No subject] - by - 09-11-2011, 07:44 PM
[No subject] - by - 09-21-2011, 10:40 AM
[No subject] - by - 09-21-2011, 10:57 AM
[No subject] - by - 10-10-2011, 05:27 PM
[No subject] - by - 10-10-2011, 08:23 PM
[No subject] - by - 10-17-2011, 08:18 PM
[No subject] - by - 10-17-2013, 05:35 AM
[No subject] - by - 10-17-2013, 05:48 AM
[No subject] - by - 10-17-2013, 07:06 AM
[No subject] - by - 10-17-2013, 07:49 AM
[No subject] - by - 10-17-2013, 09:39 AM
[No subject] - by - 10-17-2013, 09:53 AM
[No subject] - by - 10-17-2013, 09:58 AM
[No subject] - by - 10-17-2013, 11:16 AM
[No subject] - by - 12-16-2013, 08:26 AM
[No subject] - by - 12-16-2013, 08:46 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)