kEYPAD NOT TAKING CODES, KT01 NO VOICE ETC

[wiredhome]

Hi Chiu

Just installed an old system firmware 5.054 as a demo in our new distribution centre
The following is happening.

The Keypad will allow me to set the alarm but not unset it

The KT01 allows me to unset but there is no voice

There is a SCS 3 comms fault on the keypad

I cannot do the transfer with Comfigurator
 
I enter the engineer code  in the box press F0 keypad or the KT01 and press OK

I then get \"Invalid logon\" message

I even tried with comfigurator 2.9.x.x beta

I have checked all the wiring and there is no shorts. file attached

regards
Niall