+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: UCMs (https://www.comfortforums.com/forum-146.html)
+---- Forum: UCM Firmware (https://www.comfortforums.com/forum-81.html)
+---- Thread: UCM 7.069/7.072/7.075/7.076 (/thread-4213.html)
- slychiu - 05-22-2015
UCM 7.069
- Added b?00 query all zones bypass state, reply b?00zzzz where each bit is a zone bypass state.
- add Ke command for KT03 write system properties in sector
- slychiu - 07-18-2015
UCM 7.072 changes
- Fixed Bug log out on UCM/ETH03 on both ports did not disable Priority polling for UCM/Zwave for Comfort apps
- slychiu - 12-17-2015
UCM 7.075
Fixed a bug found in certain combinations of modules where Comfigurator logs in and gets an NA reply during the initial queries. Firmware released
Known BUGs
- COPY Button set ID could not set to maximum 8 From UCM 7.072
- If an empty message is sent to the UCM serial port (by Comfigurator or other software), it will cause the UCM to hang. The UCM must be reset
- slychiu - 01-11-2016
UCM 7.075 Bug
- If an empty message is sent to the UCM serial port (by Comfigurator or other software), it will cause the UCM to hang. The UCM must be reset
- slychiu - 01-11-2016
UCM 7.076 fixes the bug in 7.075 where the entry of a message with no content causes the UCM to hang.
This is not likely to occur using Comfigurator or other software like Comfortclient or the Comfort mobile and tablet apps. However the firmware should be upgraded nevertheless