+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: GSM Module (https://www.comfortforums.com/forum-48.html)
+---- Forum: UCM/GSM Firmware (https://www.comfortforums.com/forum-98.html)
+---- Thread: UCM/GSM4 7.030 (/thread-3588.html)
- ident - 11-06-2013
The UCM/GSM4 firmware 7.030 has been released
This supports UCM/GSM4 features
To upgrade firmware and UCM/GSM3 to UCM/GSM4 see the topic http://www.comfortforums.com/forum48/3527.html
If an 256K bits EEPROM is not inserted in the U2 socket, UCM/GSM4 will behave like UCM/GSM3 ie it will not send Help messages and status messages by SMS
Please take not of known bugs below
Known Bugs
- When \'the H\' is shunted, the network strength is wrongly reported in Comfigurator and on-board LEDS shown are wrong. However, if the UCM/GSM4 is de-selected and reselected again, the strength reported in Comfigurator is correct.
- When UCM/GSM loses communication or communication restore, the second phone number in Security Mode tab is not dialled out. Instead, the first phone number is dialled twic
- If no feedback type assignment in Control Item, the reply SMS has missing \"Control Group\" and \"Control Item\" field.
Note that non-english alphabet is not supported yet eg Chinese, Japanese, Arabic
Incoming SMS commands in other languages may be accepted if the message has only (, numbers and ) characters