+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Firmware Upgrading Problems (https://www.comfortforums.com/forum-111.html)
+---- Thread: Updating firmware UCM/ETH2 error and not comunication. (/thread-3277.html)
Pages:
1
2
- slychiu - 02-13-2013
Thats good. Upgrade both UCMMs to the latest version 7 firmware
Then try upgrading the UCM again without the programming cable using Comfigurator 3.6.4