Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register

Outputs not working
 Moderated by: slychiu Page:  First Page Previous Page  1  2   
 New Topic   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Wednesday Mar 25th, 2015 11:45 am
   
21st Post
Swiss-Toni
UCM Pi Users


Joined: Thursday Sep 15th, 2011
Location: Greater London, United Kingdom
Posts: 349
Status: 
Offline

  back to top

The thermostat settings have no bearing on this problem, the likelihood is that the No1 output is completely fried as the OP1 Board has been changed and swopped round and output does not respond under any conditions. the initial problem was caused by an IR wired incorrectly, although the OP1 blew as it was supposed to, it also took the rest the No1 output. as it is only one output I am not overly concerned, I was just checking to see if their was a remedy to correct it even if it requires replacing a resistor etc......



 Posted: Wednesday Mar 25th, 2015 04:28 pm
   
22nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Can you send your cclx file to support@cytech.biz so we can check if there is a problem with the settings?



 Posted: Wednesday Mar 25th, 2015 05:33 pm
   
23rd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Can you check if this bug applies to you? From Comfigurator 3.9.5 onwards

  1. Read from Comfort will cause Functions > Thermostats to fill up the unused Thermostats with sensor 0 and assign Heating and Cooling Outputs to Output 1. You will not be able to control Output 0 after reading from Comfort.  In order to free up Output 0, unasssign the outputs from each Thermostat



 Posted: Thursday Mar 26th, 2015 06:17 pm
   
24th Post
Swiss-Toni
UCM Pi Users


Joined: Thursday Sep 15th, 2011
Location: Greater London, United Kingdom
Posts: 349
Status: 
Offline

  back to top

CytechMartin wrote: Could you open your programming file and go to "Functions"--> "Thermostats". If you are not using thermostats. please ensure that all "Sensor" are "Unassigned"(see attachment).

I followed your instruction on un-assigning the thermostats, and writing it to comfort. it still displayed the same issue. However i then used the new version of comfigurator, Comfigurator 3.10.1 (Beta) today and applied the same method and to my surprise Output 1 came back up (not used Output1 for a year or so).
So I am now eating Humble Pie, & thanks for the info.......


ADMIN NOTE
This bug n Comfigurator is fixed in 3.10.2

Last edited on Monday Apr 20th, 2015 04:52 pm by slychiu



 Current time is 11:50 amPage:  First Page Previous Page  1  2   
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems