| Posted: Thursday Oct 18th, 2012 01:28 am |
|
1st Post |
jlbeng
Member
| Joined: | Tuesday Jun 12th, 2012 |
| Location: | |
| Posts: | 7 |
| Status: |
Offline
|
back to top
|
We have few panels having the same problem the first time it was powered up (new panels from the box). LCD display returned to "wrong Text" even after downloading. These are system information:
Firmware: Comfort II Ultra
Version: 6.011
File System:34
Vocabulary No.: 0
Custom Vocabulary: No
System Vocabulary Version: 0
LCD Text Version: 0
LCD KP Minimum Version: 0
UCM Type: 10
Version: 6.008
Attempted to do Vocab upgrade, Process stopped at "0%" followed by error code 6.
What could be wrong?
jlb
|
| Posted: Thursday Oct 18th, 2012 01:58 am |
|
2nd Post |
ident
Administrator
| Joined: | Wednesday Aug 9th, 2006 |
| Location: | Singapore |
| Posts: | 3493 |
| Status: |
Offline
|
back to top
|
System Vocabulary Version = 0 means the voice is lost
That means that there is no voice on the keypad.
You need to do a Vocabulary Upgrade to restore the voice.
See the topic at http://comfortforums.com/forum76/1623.html for instructions on how to do this
|
| Posted: Thursday Oct 18th, 2012 02:57 am |
|
3rd Post |
jlbeng
Member
| Joined: | Tuesday Jun 12th, 2012 |
| Location: | |
| Posts: | 7 |
| Status: |
Offline
|
back to top
|
Hv tried that. Attempted to do Vocab upgrade,
Process stopped at "0%" followed by error code 6.
No Slave & Keypad was not attached during the process.
Hv tried restarted panel as well as restarted comfigurator.
Thnks.
jlb
|
| Posted: Thursday Oct 18th, 2012 05:45 am |
|
4th Post |
ident
Administrator
| Joined: | Wednesday Aug 9th, 2006 |
| Location: | Singapore |
| Posts: | 3493 |
| Status: |
Offline
|
back to top
|
Error Code 6 means "Failed to Erase" so this is due to a fault on the board, perhaps caused by a lightning surge
Please return to distributor for repairs
|
| Posted: Thursday Oct 18th, 2012 06:02 am |
|
5th Post |
jlbeng
Member
| Joined: | Tuesday Jun 12th, 2012 |
| Location: | |
| Posts: | 7 |
| Status: |
Offline
|
back to top
|
These are new boards to be programmed before installation at site. Possibilities of lightning can be ruled out. Approx. 10 out of 160 boards hv this problem. Reluctant to send back to distributor cause very slow response. Other ways to try?
Jlb
|
| Posted: Thursday Oct 18th, 2012 08:28 am |
|
6th Post |
ident
Administrator
| Joined: | Wednesday Aug 9th, 2006 |
| Location: | Singapore |
| Posts: | 3493 |
| Status: |
Offline
|
back to top
|
Do you get error code 6 on all of the 10 boards?
We dont expect 10 out of 160 to have the fault
Can you send a few of them directly to us for testing? Can you send an email to support@cytech.biz
|
|
