Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Support > KNX 1 bit switching map to Comfort Away Arm not working

KNX 1 bit switching map to Comfort Away Arm not working
 Moderated by: ident
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Monday Nov 25th, 2013 10:30 am
   PM  Quote  Reply 
1st Post
evard
Member
 

Joined: Monday Sep 2nd, 2013
Location:  
Posts: 23
Status: 
Offline

  back to top

Hi expert,

I was trying to map KNX button to Comfort Away Arm.
But I is not working.

Besides that, then "Learn" function is not working too.

I am able to test the "On", "Off" by manually set the KNX address.

Please guide me on this.

Comfort OPT version: 6.028
UCM/KNX version: 6.112

Edit: KNX to Comfort is not working, but Comfort to KNX is working fine.

Thank you!

Last edited on Monday Nov 25th, 2013 10:30 am by evard



 Posted: Monday Nov 25th, 2013 11:36 am
   PM  Quote  Reply 
2nd Post
ident
Administrator


Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

I was trying to map KNX button to Comfort Away Arm. But I is not working.
Can you explain exactly what you did?

KNX to Comfort?
did you assign group address Type = Arm to Away? as 1 -bit?

If so it definately will work especially as you say KNX to Comfort is working



Besides that, then "Learn" function is not working too.
The Learn function allows you to see the KNX group addresses as they are sent on the Bus. So you have to press a KNX switch while in learn mode, otherwise nothing will happen


KNX to Comfort is not working, but Comfort to KNX is working fine.
Did you assign any group address to Comfort to KNX?
How do you know it is not working?
These alarm conditions are sent  to the mapped KNX group address

The UCM/KNX Manual can be downloaded from http://www.cytech.biz/ucmknx_manual.html and shows how it should work













 Posted: Monday Nov 25th, 2013 01:12 pm
   PM  Quote  Reply 
3rd Post
evard
Member
 

Joined: Monday Sep 2nd, 2013
Location:  
Posts: 23
Status: 
Offline

  back to top

Thanks for your reply.

I think that is the problem from my push button because it is working when I send the 1-bit value from ETS Group Monitoring.

But not working when I configured my push button to "Switching" OR "1-bit value sender".

Will try to figure it out myself.



 Current time is 02:28 pm
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Support > KNX 1 bit switching map to Comfort Away Arm not working
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems